2014 Hilux · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. INSTALL STARTER CLUTCH SUB-ASSEMBLY
  1. Apply high-temperature grease to the idler gear, steel ball, return spring, clutch roller and retainer.

  1. A197147
    Install the steel ball.

  1. Insert the return spring into the starter clutch hole.

  1. Install the starter clutch assembly, idler gear, retainer and clutch roller to the starter drive housing.

    A122572E02

  1. A102626
    Install the starter drive housing to the magnet starter switch with the 3 screws.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }


2. INSTALL STARTER ARMATURE ASSEMBLY

  1. A071182
    Install the starter armature to the starter yoke.


3. INSTALL STARTER BRUSH HOLDER ASSEMBLY
  1. Install the starter brush holder to the starter yoke.

  1. Install the 4 starter brushes to the starter brush holder.

    1. A112474
      Using a screwdriver, pull back the spring.

    2. Install the starter brush to the starter brush holder.

      NOTICE:
      Check that the positive (+) lead wires are not grounded.

  1. A102628
    Install the commutator end frame with the 2 screws.

    Torque:
    3.6 N*m{ 37 kgf*cm , 32 in.*lbf }


4. INSTALL STARTER YOKE ASSEMBLY

  1. A197145
    Align the protrusion of the starter yoke with the groove of the magnet starter switch, and install the starter yoke and starter armature.

  1. A102625E01
    Install the 2 through bolts.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }

  1. Connect the lead wire to terminal C with the nut.

    Torque:
    24 N*m{ 245 kgf*cm , 18 in.*lbf }

← INSPECTION (from Jun 2011)INSTALLATION (Jun 2011 – Jul 2012) →