2014 Hilux · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. INSTALL STARTER CLUTCH SUB-ASSEMBLY
  1. Apply high-temperature grease to the idler gear, pinion gear, steel ball, return spring, clutch roller and retainer.

  1. P005018
    Install the steel ball.

  1. Insert the return spring into the starter clutch hole.

  1. Install the starter clutch, pinion gear, idler gear, retainer and clutch roller to the starter drive housing.

    A121006E02

  1. A289336
    Install the starter drive housing to the magnet starter switch with the 2 screws.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }


2. INSTALL STARTER ARMATURE ASSEMBLY
  1. Install the starter armature to the starter yoke.


3. INSTALL STARTER BRUSH HOLDER ASSEMBLY
  1. Install a new O-ring to the groove of the starter yoke.

  1. Install the starter brush holder to the starter yoke.

  1. Install the 4 starter brushes to the starter brush holder.

    1. A115022
      Using a screwdriver, pull back the spring.

    2. Install the brush to the brush holder.

      NOTICE:
      Check that the positive (+) lead wires are not grounded.

  1. A115021
    Install the commutator end frame with the 2 screws.

    Torque:
    3.8 N*m{ 39 kgf*cm , 34 in.*lbf }


4. INSTALL STARTER YOKE ASSEMBLY
  1. Install a new O-ring to the groove of the starter yoke.

  1. A115017
    Align the protrusion of the starter yoke with the groove of the magnet starter switch.

  1. A074096
    Install the starter yoke with the 2 through bolts.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }

  1. Connect the lead wire to terminal C with the nut.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }

← INSPECTION (from Jun 2011)INSTALLATION (Jun 2011 – Jul 2012) →