VC Output Circuit
Circuit diagnosis · Vehicles built from Jun 2011
DESCRIPTION
The VC voltage (5 V) is generated in the ECM. The voltage is used to supply power to the throttle position sensor, canister pump module, etc.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK MIL |
Check that MIL (Malfunction Indicator Lamp) lights up when turning the ignition switch ON.
- OK:
- MIL lights up
|
|
||||
| NG | |
| 2. CHECK CONNECTION BETWEEN INTELLIGENT TESTER AND ECM |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the intelligent tester ON.
Check the connection between the intelligent tester and ECM.
- Result:
Condition
Proceed to
Communication is possible
A
Communication is not possible
B
|
|
||||
| B | |
| 3. INSPECT ECM (VC VOLTAGE) |
![]() ![]() |
Turn the ignition switch ON.
Measure the voltage of the ECM connector.
- Standard voltage:
Tester Connection
Specified Condition
E12-18 (VC) - E12-3 (E1)
Voltage is not 5 V
| NEXT | |
| 4. CHECK MIL (THROTTLE POSITION SENSOR) |
Disconnect the T25 throttle body connector.
Turn the ignition switch ON.
Check the MIL.
- Result:
Condition
Proceed to
MIL illuminates
A
MIL does not illuminate
B
|
|
||||
| B | |
| 5. CHECK MIL (ACCELERATOR PEDAL POSITION SENSOR) |
Disconnect the A13 accelerator pedal position sensor connector.
Turn the ignition switch ON.
Check the MIL.
- Result:
Condition
Proceed to
MIL illuminates
A
MIL does not illuminate
B
|
|
||||
| B | |
| 6. CHECK MIL (VARIABLE RESISTOR) |
Disconnect the V4 variable resistor connector.
Turn the ignition switch ON.
Check the MIL.
- Result:
Condition
Proceed to
MIL illuminates
A
MIL does not illuminate
B
|
|
||||
| B | |
| 7. CHECK WIRE HARNESS (ECM - BODY GROUND) |
![]() ![]() |
Disconnect the T25 throttle body connector.
Disconnect the A13 accelerator pedal position sensor connector.
Disconnect the V4 variable resistor connector.
Disconnect the E9 and E12 ECM connectors.
Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
Specified Condition
E12-18 (VC) - Body ground
10 kΩ or higher
E9-26 (VCPA) - Body ground
10 kΩ or higher
E9-27 (VCP2) - Body ground
10 kΩ or higher
|
|
||||
| OK | ||
| ||


