2014 Hilux · Service Manual ENGINE

ECM Back-up Power Source Circuit

Circuit diagnosis · Vehicles built from Jun 2011

DESCRIPTION

While the ignition switch is OFF, battery voltage is supplied to terminal BATT of the ECM for the DTC memory, air-fuel ratio adaptive control value memory, etc.

WIRING DIAGRAM

A120227E01

INSPECTION PROCEDURE


1. INSPECT FUSE (EFI)
G034719E06
  1. Remove the EFI fuse from the engine room junction block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
CHECK FOR SHORT IN ALL HARNESSES AND COMPONENTS CONNECTED TO FUSE
OK


2. CHECK ECM (BATT VOLTAGE)
A066060E25
  1. Turn the ignition switch ON.

  1. Measure the voltage of the ECM connectors.

    Standard voltage:
    Tester Connection
    Specified Condition
    E9-3 (BATT) - E12-3 (E1)
    8 to 14 V



OK
REPLACE ECM
NG


3. CHECK WIRE HARNESS (ECM - EFI FUSE, EFI FUSE - BATTERY)
G034712E03
  1. Check the wire harness between the EFI fuse and ECM.

    1. Remove the EFI fuse from the engine room junction block.

    2. Disconnect the E9 ECM connector.

    3. Measure the resistance of the wire harness side connectors.

      Standard resistance:
      Tester Connection
      Specified Condition
      J/B EFI fuse terminal 2 - E9-3 (BATT)
      Below 1 Ω
      J/B EFI fuse terminal 2 or E9-3 (BATT) - Body ground
      10 kΩ or higher

  1. Check the wire harness between the EFI fuse and battery.

    1. Remove the EFI fuse from the engine room junction block.

    2. Disconnect the positive (+) battery cable.

    3. Measure the resistance of the wire harness side connectors.

      Standard resistance:
      Tester Connection
      Specified Condition
      Positive (+) battery cable - J/B EFI fuse terminal 1
      Below 1 Ω
      Positive (+) battery cable or J/B EFI fuse terminal 1 -
      Body ground
      10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE ENGINE ROOM RELAY BLOCK


← VC Output Circuit (from Jun 2011)Fuel Pump Control Circuit (from Jun 2011) →