2014 Hilux · Service Manual ENGINE

VC Output Circuit

Circuit diagnosis · Vehicles built from Jun 2011

DESCRIPTION

The VC voltage (5 V) is generated in the ECM. The voltage is used to supply power to the throttle position sensor, canister pump module, etc.

WIRING DIAGRAM

A174088E05

INSPECTION PROCEDURE


1. CHECK MIL
  1. Check that MIL (Malfunction Indicator Lamp) lights up when turning the ignition switch ON.

OK:
MIL lights up



OK
SYSTEM OK
NG


2. CHECK CONNECTION BETWEEN INTELLIGENT TESTER AND ECM
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON and turn the intelligent tester ON.

  1. Check the connection between the intelligent tester and ECM.

Result:
Condition
Proceed to
Communication is possible
A
Communication is not possible
B



A
GO TO MIL CIRCUIT
B


3. INSPECT ECM (VC VOLTAGE)
A119979E34
  1. Turn the ignition switch ON.

  1. Measure the voltage of the ECM connector.

Standard voltage:
Tester Connection
Specified Condition
E12-18 (VC) - E12-3 (E1)
Voltage is not 5 V


NEXT


4. CHECK MIL (THROTTLE POSITION SENSOR)
  1. Disconnect the T25 throttle body connector.

  1. Turn the ignition switch ON.

  1. Check the MIL.

Result:
Condition
Proceed to
MIL illuminates
A
MIL does not illuminate
B



A
REPLACE THROTTLE BODY
B


5. CHECK MIL (ACCELERATOR PEDAL POSITION SENSOR)
  1. Disconnect the A13 accelerator pedal position sensor connector.

  1. Turn the ignition switch ON.

  1. Check the MIL.

Result:
Condition
Proceed to
MIL illuminates
A
MIL does not illuminate
B



A
REPLACE ACCELERATOR PEDAL POSITION SENSOR
B


6. CHECK WIRE HARNESS (ECM - BODY GROUND)
A079127E08
  1. Disconnect the T25 throttle body connector.

  1. Disconnect the A13 accelerator pedal position sensor connector.

  1. Disconnect the E9 and E12 ECM connectors.

  1. Measure the resistance of the wire harness side connector.

Standard resistance:
Tester Connection
Specified Condition
E12-18 (VC) - Body ground
10 kΩ or higher
E9-26 (VCPA) - Body ground
10 kΩ or higher
E9-27 (VCP2) - Body ground
10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE ECM


← ECM Power Source Circuit (from Jun 2011)ECM Back-up Power Source Circuit (from Jun 2011) →