2014 Hilux · Service Manual HEATER & AIR CONDITIONING SYSTEM

INSPECTION

Inspection · Vehicles built from Jun 2011


INSPECT COOLER THERMISTOR (SOLAR SENSOR)

E225715E01
  1. Connect the connector.

  1. Turn the ignition switch to ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    1 (SS+) - 2 (SS-)
    Sensor not exposed to sunlight or inspection light
    Below 0.8 V
    Sensor exposed to sunlight or inspection light
    0.8 to 4.3 V

    If the resistance is not as specified, replace the cooler thermistor (solar sensor).

    HINT:
    1. Check from the rear of the connector while it is connected to the cooler thermistor (solar sensor).
    2. Use an incandescent light for inspection. Bring it within about 30 cm (11.8 in.) of the cooler thermistor (solar sensor).

    Text in Illustration 
    *a
    Component with harness connected
    (Cooler Thermistor (Solar Sensor))

← REMOVAL (from Jun 2011)INSTALLATION (from Jun 2011) →