2014 Hilux · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Jun 2011

NOTICE:
Release the vacuum from the booster by depressing the brake pedal several times. Then remove the brake master cylinder sub-assembly from the brake booster assembly.


1. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.


2. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

C197299E01
  1. for Manual Transmission:
    Disconnect the clutch reservoir tube from the master cylinder reservoir.

  1. Disconnect the brake fluid level warning switch connector.

  1. Using a union nut wrench, disconnect the 4 brake lines from the master cylinder and brake tube way.

  1. C197308E01
    Remove the 2 nuts and brake tube way.

  1. Pull out the master cylinder from the brake booster.

  1. Remove the O-ring from the master cylinder.

← COMPONENTS (from Jun 2011)DISASSEMBLY (from Jun 2011) →