2014 Hilux · Service Manual ENGINE

P0069 MAP Sensor Too High or Too Low

Diagnostic trouble codes · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

To detect atmospheric pressure, the atmospheric pressure sensor built into the ECM is used in the common rail system. Following the changes in the atmospheric pressure, the ECM corrects the fuel injection volume, timing and duration, and adjusts the common rail internal fuel pressure for optimizing combustion.
DTC No.
DTC Detection Condition
Trouble Area
P0069
Atmospheric pressure sensor malfunction
(2 trip detection logic)
ECM

INSPECTION PROCEDURE

NOTICE:
After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).

HINT:
Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0069)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON and turn the tester ON.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Read the DTCs.

    Result:
    Display (DTC Output)
    Proceed to
    P0069 and other DTCs
    A
    P0069
    B

    HINT:
    If codes other than P0069 are output, perform troubleshooting for those DTCs first.



B
REPLACE ECM
A

GO TO DTC CHART


← P0047 Turbocharger/Supercharger Boost Control "A" Circuit Low (+ P0048) (from Aug 2014)P0069 MAP Sensor Too High or Too Low (Aug 2012 – Jul 2013) →