2014 Hilux · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. REMOVE GENERATOR PULLEY

  1. A075664E06
    Install SST 1-A and B to the generator rotor shaft.
    SST
    09820-63011   (09820-06010, 09820-06021)
    Item
    Part No.
    SST 1-A and B
    09820-06010
    SST 2
    09820-06021

  1. Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise with the specified torque.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }

    NOTICE:
    Make sure that the SST is secured to the generator rotor shaft.

  1. Mount the generator in a vise between aluminum plates.

  1. A203850E01
    Insert SST 2 to attach it to the pulley nut.

  1. A203851E01
    To loosen the pulley nut, turn SST 1-A in the direction shown in the illustration.

    NOTICE:
    To prevent damage to the rotor shaft, do not loosen the pulley nut more than one-half turn.

  1. Remove SST 2 from the generator.

  1. A075667E05
    Turn SST 1-B in the direction shown in the illustration, and remove SST 1-A and B.

  1. Remove the pulley nut and pulley.


2. REMOVE GENERATOR REAR END COVER

  1. A118436
    Remove the 3 nuts and generator rear end cover.


3. REMOVE TERMINAL INSULATOR

  1. A118437
    Remove the terminal insulator.


4. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY

  1. A118438
    Remove the 2 screws and brush holder.


5. REMOVE GENERATOR COIL ASSEMBLY

  1. A118439
    Remove the 4 bolts.

  1. A115868E01
    Using SST, remove the generator coil assembly.
    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)


6. REMOVE GENERATOR ROTOR ASSEMBLY
  1. Remove the washer from the generator rotor.

  1. Remove the drive end frame space collar.

  1. Remove the rotor from the drive end frame.


7. INSPECT GENERATOR DRIVE END FRAME BEARING

  1. A118440
    Check that the bearing is not rough or worn, and that it rotates smoothly.
    If necessary, replace the drive end frame bearing.


8. REMOVE GENERATOR DRIVE END FRAME BEARING

  1. A118441
    Remove the 4 screws and bearing retainer.

  1. A118442E01
    Using SST and a hammer, tap out the bearing.
    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)

← REMOVAL (from Aug 2013)INSPECTION (from Jun 2011) →