2014 Hilux · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Jun 2011


INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

  1. A118443E01
    Using a vernier caliper, measure the brush length.

    Standard length:
    10.5 mm (0.413 in.)

    Minimum length:
    4.5 mm (0.177 in.)

    If the brush length is less than the minimum, replace the brush holder assembly.


INSPECT GENERATOR ROTOR ASSEMBLY

  1. A118444
    Check that the bearing is not rough or worn, and that it rotates smoothly.
    If necessary, replace the rotor assembly.

  1. Check the resistance.

    1. A236749E01
      Measure the resistance between the slip rings.

      Standard resistance:
      1.85 to 2.25 Ω at 20°C (68°F)

      If the result is not as specified, replace the rotor assembly.

    2. A236750E01
      Measure the resistance between the slip ring and rotor core.

      Standard resistance:
      10 kΩ or higher

      If the result is not as specified, replace the rotor assembly.

  1. Check each slip ring.

    1. Check that the slip rings are not rough or scored.
      If rough or scored, replace the rotor assembly.

    2. A118447E01
      Using a vernier caliper, measure the slip ring diameter.

      Standard diameter:
      14.2 to 14.4 mm (0.559 to 0.567 in.)

      Minimum diameter:
      14.0 mm (0.551 in.)

      If the diameter is less than the minimum, replace the rotor assembly.

← DISASSEMBLY (from Jun 2011)REASSEMBLY (from Jun 2011) →