2014 Hilux · Service Manual SECURITIES

Horn Circuit

Circuit diagnosis · Vehicles built from Jun 2011

DESCRIPTION

When the theft deterrent system is changed from the armed state to the alarm sounding state, the theft warning ECU assembly turns on the HORN relay, causing the vehicle horn to sound at 0.4 seconds intervals.

WIRING DIAGRAM

B287095E01

INSPECTION PROCEDURE

NOTICE:
When replacing the theft warning ECU assembly, refer to the registration procedures (Click here).


1. CHECK HORN ASSEMBLY
  1. Press the horn switch and check if the horn sounds.

    Result 
    Result
    Proceed to
    Horn sounds
    A
    Horn does not sound
    B



B
Go to HORN SYSTEM (Click here)
A


2. CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU - NO. 1 INTEGRATION RELAY [HORN RELAY])
  1. Disconnect the T36*1 or T39*2 theft warning ECU assembly connector.

    1. *1: except 2 Step Unlock Function
    2. *2: for 2 Step Unlock Function

  1. Disconnect the 1I driver side junction block assembly connector.

  1. Measure the resistance according to the value in the table below.

    Standard Resistance:
    except 2 Step Unlock Function:
    Tester Connection
    Condition
    Specified Condition
    T36-11 (HORN) - 1I-7
    Always
    Below 1 Ω
    T36-11 (HORN) or 1I-7 - Body ground
    Always
    10 kΩ or higher
    for 2 Step Unlock Function:
    Tester Connection
    Condition
    Specified Condition
    T39-24 (HORN) - 1I-7
    Always
    Below 1 Ω
    T39-24 (HORN) or 1I-7 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE THEFT WARNING ECU ASSEMBLY


← Engine Hood Courtesy Switch Circuit (from Jun 2011)Security Horn Circuit (from Jun 2011) →