2014 Hilux · Service Manual SECURITIES

Engine Hood Courtesy Switch Circuit

Circuit diagnosis · Vehicles built from Jun 2011

DESCRIPTION

The security courtesy switch (engine hood courtesy switch) is installed together with the hood lock. This switch turns OFF when the engine hood is opened and turns ON when the engine hood is closed.

WIRING DIAGRAM

B287096E01

INSPECTION PROCEDURE


1. INSPECT HOOD LOCK ASSEMBLY (SECURITY COURTESY SWITCH)
B282278E01
  1. Remove the the hood lock assembly (security courtesy switch).

    1. for LHD: Click here
    2. for RHD: Click here

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Unlock position
    10 kΩ or higher
    1 - 2
    Lock position
    Below 1 Ω

    Text in Illustration 
    *a
    Unlock position
    *b
    Lock position
    Result 
    Result
    Proceed to
    OK
    A
    NG (for LHD)
    B
    NG (for RHD)
    C



B
REPLACE HOOD LOCK ASSEMBLY (SECURITY COURTESY SWITCH) (Click here)

C
REPLACE HOOD LOCK ASSEMBLY (Click here)
A


2. CHECK HARNESS AND CONNECTOR (SECURITY COURTESY SWITCH - THEFT WARNING ECU AND BODY GROUND)
  1. Disconnect the E3 hood lock assembly (security courtesy switch) connector.

  1. Disconnect the T36*1 or T39*2 theft warning ECU assembly connector.

    1. *1: except 2 Step Unlock Function
    2. *2: for 2 Step Unlock Function

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    except 2 Step Unlock Function:
    Tester Connection
    Condition
    Specified Condition
    E3-1 - T36-9 (DSWH)
    Always
    Below 1 Ω
    E3-1 or T36-9 (DSWH) - Body ground
    Always
    10 kΩ or higher
    E3-2 - Body ground
    Always
    Below 1 Ω
    for 2 Step Unlock Function:
    Tester Connection
    Condition
    Specified Condition
    E3-1 - T39-9 (DSWH)
    Always
    Below 1 Ω
    E3-1 or T39-9 (DSWH) - Body ground
    Always
    10 kΩ or higher
    E3-2 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← TERMINALS OF ECU (from Nov 2011)Horn Circuit (from Jun 2011) →