2014 Hilux · Service Manual SECURITIES

Rear Door Courtesy Switch RH Circuit

Circuit diagnosis · Vehicles built from Jun 2011

DESCRIPTION

The theft warning ECU assembly detects the condition of the rear door courtesy light switch assembly RH.

WIRING DIAGRAM

B287277E03

INSPECTION PROCEDURE


1. INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY RH

  1. B276106E01
    Remove the rear door courtesy light switch assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - Body ground
    Not pushed (ON)
    Below 1 Ω
    1 - Body ground
    Pushed (OFF)
    10 kΩ or higher

    Text in Illustration 
    *a
    Not pushed (ON)
    *b
    Pushed (OFF)
    *c
    Body ground



NG
REPLACE REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY RH (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (REAR DOOR COURTESY LIGHT SWITCH RH - THEFT WARNING ECU)
  1. Disconnect the D5 rear door courtesy light switch assembly RH connector.

  1. Disconnect the T36*1 or T39*2 theft warning ECU assembly connector.

    1. *1: except 2 Step Unlock Function
    2. *2: for 2 Step Unlock Function

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    except 2 Step Unlock Function:
    Tester Connection
    Condition
    Specified Condition
    D5-1 - T36-7 (CTY)
    Always
    Below 1 Ω
    D5-1 or T36-7 (CTY) - Body ground
    Always
    10 kΩ or higher
    for 2 Step Unlock Function:
    Tester Connection
    Condition
    Specified Condition
    D5-1 - T39-7 (CTY)
    Always
    Below 1 Ω
    D5-1 or T39-7 (CTY) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Rear Door Courtesy Switch LH Circuit (from Jun 2011)Starter Relay Circuit (Jun 2011 – Oct 2011) →