Circuit diagnosis · Vehicles built Jun 2011 – Oct 2011
Versions by build date: Jun 2011 – Oct 2011from Nov 2011
DESCRIPTION
When the theft deterrent system operates, the theft warning ECU assembly deactivates the ST relay so that the starter cannot crank the engine.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
If the engine cranks but does not start, there is a problem with the SFI system*1 or ECD system*2. If this is the case, refer to SFI System*1 or ECD System*2 and perform troubleshooting.
*1: for 2TR-FE
*2: for 1KD-FTV, 2KD-FTV
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
When replacing the theft warning ECU assembly, refer to the registration procedures (Click here).
1. INSPECT ST RELAY
Remove the ST relay from the engine room relay block and junction block assembly.
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
3 - 5
Battery voltage is not applied to terminals 1 and 2