DISASSEMBLY
Removal / installation · Vehicles built from Aug 2012
Versions by build date: Jun 2011 – Jul 2012 from Aug 2012
| 1.
REMOVE RADIATOR BRACKET SUB-ASSEMBLY |
 |
- Remove the 4 bolts and 2 radiator brackets.
| 2.
REMOVE RADIATOR DRAIN COCK PLUG |
 |
Remove the radiator drain cock plug.
Remove the O-ring.
| 3.
ASSEMBLE SST |
 |
- Install the claw to part A of the overhaul handle as shown in the illustration.
- SST
- 09230-01010
(09231-01010, 09231-01030)
Text in Illustration
*1
|
Dimension B
|
*2
|
Part A
|
*3
|
Stopper Bolt
|
While squeezing the handle, adjust the stopper bolt so that dimension B is as specified below.
- Dimension B:
- 0.2 to 0.3 mm (0.00787 to 0.0118 in.)
- NOTICE:
- If this adjustment is not performed, the claw will be damaged.
| 4.
UNCAULK LOCK PLATE |
 |
- Using SST to release the caulking, squeeze the handle until stopped by the stopper bolt.
- SST
- 09230-01010
(09231-01010, 09231-01030)
Text in Illustration
*1
|
Tank
|
*2
|
Lock Plate
|
| 5.
REMOVE UPPER RADIATOR TANK AND LOWER RADIATOR TANK |
 |
- Lightly tap the bracket of the radiator (or radiator hose inlet or outlet) with a plastic-faced hammer and remove the tanks.
- NOTICE:
- Do not tap automatic transmission oil cooler pipe.
Remove the O-ring.
| 6.
REMOVE OIL COOLER (for Automatic Transmission) |
 |
- Remove the 2 cooler pipes.
Remove the 2 nuts, 2 plate washers and oil cooler.
Remove the 2 O-rings from the oil cooler.