REMOVAL
Removal / installation · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
- Use the same procedure for RHD and LHD vehicles.
| 1. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
for Manual Air Conditioning System:
Put protective tape around the center instrument cluster finish panel.

Text in Illustration *1
Protective Tape
Using a moulding remover, detach the 10 claws and 4 clips.
Detach the 4 claws and disconnect the air conditioner control.

Disconnect the connectors and remove the center instrument cluster finish panel.
for Automatic Air Conditioning System:
Put protective tape around the center instrument cluster finish panel.

Text in Illustration *1
Protective Tape
Using a moulding remover, detach the 8 claws and 4 clips.
Disconnect the connectors and remove the center instrument cluster finish panel.
| 2. REMOVE INTEGRATION PANEL SUB-ASSEMBLY |
Remove the 4 screws.

Remove the 4 screws.

Detach the 3 claws and disconnect the lower heater control base.
Disconnect the No. 1 cooler wire from the integration panel sub-assembly (air conditioning panel) as shown in the illustration.

- NOTICE:
- Before performing the procedure above, the hazard switch must be turned off. If the switch is on while the base is removed, damage will occur to the switch.
