2014 Hilux · Service Manual HEATER & AIR CONDITIONING SYSTEM

REMOVAL

Removal / installation · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

  1. for Manual Air Conditioning System:

    1. B278367E01
      Put protective tape around the center instrument cluster finish panel.
      Text in Illustration 
      *1
      Protective Tape

    2. Using a moulding remover, detach the 10 claws and 4 clips.

    3. B278366
      Detach the 4 claws and disconnect the air conditioner control.

    4. Disconnect the connectors and remove the center instrument cluster finish panel.

  1. for Automatic Air Conditioning System:

    1. B278368E01
      Put protective tape around the center instrument cluster finish panel.
      Text in Illustration 
      *1
      Protective Tape

    2. Using a moulding remover, detach the 8 claws and 4 clips.

    3. Disconnect the connectors and remove the center instrument cluster finish panel.


2. REMOVE INTEGRATION PANEL SUB-ASSEMBLY

  1. E228137
    Remove the 4 screws.

  1. E228138
    Remove the 4 screws.

  1. Detach the 3 claws and disconnect the lower heater control base.

  1. E228139
    Disconnect the No. 1 cooler wire from the integration panel sub-assembly (air conditioning panel) as shown in the illustration.

    NOTICE:
    Before performing the procedure above, the hazard switch must be turned off. If the switch is on while the base is removed, damage will occur to the switch.

← REMOVAL (Aug 2012 – Jul 2013)INSTALLATION (Jun 2011 – Jul 2012) →