2014 Hilux · Service Manual SECURITIES

INSPECTION

Inspection · Vehicles built from Jun 2011


INSPECT HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH)

  1. for RHD:

    1. E225118E01
      Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      1 - 2
      Unlock position
      10 kΩ or higher
      1 - 2
      Lock position
      Below 1 Ω

      If the result is not as specified, replace the hood lock assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Hood Lock Assembly)
      *b
      Unlock Position
      *c
      Lock Position

  1. for LHD:

    1. E225119E01
      Measure the resistance of the hood lock assembly.

      Standard resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      1 - 2
      Unlock position
      10 kΩ or higher
      1 - 2
      Lock position
      Below 1 Ω

      If the result is not as specified, replace the hood lock assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Hood Lock Assembly)
      *b
      Unlock position
      *c
      Lock position

← ECU Power Source Circuit (from Jun 2011)INSPECTION (from Jun 2011) →