2014 Hilux · Service Manual SECURITIES

ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Jun 2011

DESCRIPTION

This circuit provides power to operate the theft warning ECU.

WIRING DIAGRAM

B287280E01

INSPECTION PROCEDURE

NOTICE:
  1. Inspect the fuses for circuits related to this system before performing the following inspection procedure.
  2. When replacing the theft warning ECU assembly, refer to the registration procedures (Click here).


1. CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU - BATTERY AND BODY GROUND)

  1. B287082E02
    Disconnect the T36*1 or T39*2 theft warning ECU connector.
    1. *1: except 2 Step Unlock Function
    2. *2: for 2 Step Unlock Function

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    except 2 Step Unlock Function:
    Tester Connection
    Condition
    Specified Condition
    T36-1 (E) - Body ground
    Always
    Below 1 Ω
    for 2 Step Unlock Function:
    Tester Connection
    Condition
    Specified Condition
    T39-1 (E) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    except 2 Step Unlock Function:
    Tester Connection
    Condition
    Specified Condition
    T36-4 (+B1) - Body ground
    Always
    11 to 14 V
    T36-14 (+B2) - Body ground
    Always
    11 to 14 V
    for 2 Step Unlock Function:
    Tester Connection
    Condition
    Specified Condition
    T39-3 (+B1) - Body ground
    Always
    11 to 14 V
    T39-12 (+B2) - Body ground
    Always
    11 to 14 V

Text in Illustration 
*A
except 2 Step Unlock Function
*B
for 2 Step Unlock Function
*a
Front view of wire harness connector
(to Theft Warning ECU Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE THEFT WARNING ECU ASSEMBLY


← Starter Relay Circuit (from Nov 2011)INSPECTION (from Jun 2011) →