DISASSEMBLY
Removal / installation · Vehicles built from Jun 2011
| 1. REMOVE RADIATOR BRACKET SUB-ASSEMBLY |
Remove the 4 bolts and 2 brackets.

| 2. REMOVE RADIATOR DRAIN COCK PLUG |
Remove the drain cock plug.
Remove the O-ring.
| 3. ASSEMBLE SST |
Install the claw to part A of the overhaul handle as shown in the illustration.

- SST
- 09230-01010
(09231-01010, 09231-01030)
While squeezing the handle, adjust the stopper bolt so that dimension B is as specified below.
- Dimension B:
- 0.2 to 0.3 mm (0.008 to 0.012 in.)
- NOTICE:
- If this adjustment is not performed, the claw will be damaged.
| 4. UNCAULK LOCK PLATE |
Using SST, squeeze the handle until stopped by the stopper bolt to release the caulking. SST

- SST
- 09230-01010
(09231-01010, 09231-01030)
| 5. REMOVE RADIATOR TANK UPPER AND RADIATOR TANK LOWER |
Lightly tap the bracket of the radiator (or the connection area for the radiator hose inlet or outlet) with a plastic-faced hammer and remove the tank.

- NOTICE:
- Do not tap automatic transmission oil cooler pipe.
Remove the O-ring.
| 6. REMOVE OIL COOLER ASSEMBLY (for Automatic Transmission) |
![]() ![]() |
Remove the 2 cooler pipes.
Remove the 2 nuts, 2 plate washers and oil cooler.
Remove the 2 O-rings from the oil cooler.

