REMOVAL
Removal / installation · Vehicles built from Jun 2011
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE RADIATOR GRILLE |
Put protective tape around the radiator grille.

Text in Illustration *1
Protective Tape
Remove the 2 clips and 2 screws.
Detach the 6 claws and remove the radiator grille.

| 3. REMOVE RADIATOR SIDE DEFLECTOR LH |
Using a clip remover, remove the 2 clips.

Detach the claw and remove the deflector.
| 4. REMOVE RADIATOR SIDE DEFLECTOR RH |
Using a clip remover, remove the 2 clips.
Detach the claw and remove the deflector.
| 5. REMOVE NO. 1 ENGINE UNDER COVER |
Remove the 4 bolts and No. 1 under cover.
| 6. DRAIN ENGINE COOLANT |
Remove the radiator cap.
Loosen the cylinder block drain cock plug and radiator drain cock plug, and then drain the coolant.
- HINT:
- Collect the coolant in a container and dispose of it according to the regulations in your area.


| 7. REMOVE RADIATOR HOSE INLET |
| 8. REMOVE RADIATOR HOSE OUTLET |
| 9. REMOVE AIR PUMP INLET (w/ Secondary Air Injection System) |
![]() ![]() |
Remove the bolts and disconnect the pump inlet.
| 10. REMOVE FAN SHROUD |
![]() ![]() |
Disconnect the reservoir hose from the radiator tank upper.
Loosen the 4 nuts holding the fluid coupling fan.
Remove the drive belt (Click here).
Remove the 2 bolts holding the fan shroud.
Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.
- NOTICE:
- Be careful not to damage the radiator core.
Remove the fan pulley from the water pump.
| 11. REMOVE OIL COOLER INLET HOSE (for Automatic Transmission) |
Disconnect the inlet hose from the radiator tank lower.
| 12. REMOVE OIL COOLER OUTLET HOSE (for Automatic Transmission) |
Disconnect the outlet hose from the radiator tank lower.
| 13. REMOVE RADIATOR ASSEMBLY |
Disconnect the 2 airbag sensor front connectors.

Using a clip remover, detach the 4 clamps from the radiator side as shown in the illustration.
- HINT:
- Tape the clip remover tip before use.
Remove the 4 bolts and radiator.



