2014 Hilux · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jun 2011


CHECK INJECTION PUMP

  1. B012956
    Inspect the engine speed sensor.

    1. Measure the resistance of the sensor.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      1 (NE-) - 2 (NE+)
      20°C (68°F)
      205 to 255 Ω

      If the result is not as specified, replace the speed sensor.

  1. B012767E01
    Inspect the spill control valve.

    1. Measure the resistance of the spill control valve.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      1 (SPV-) - 2 (SPV+)
      20°C (68°F)
      1 to 2 Ω

      If the result is not as specified, replace the injection pump.


CHECK TIMING CONTROL VALVE

  1. B012766E02
    Inspect the timing control valve.

    1. Measure the resistance of the timing control valve.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      1 (+B) - 2 (TCV)
      20°C (68°F)
      10 to 14 Ω

      If the result is not as specified, replace the timing control valve.

  1. Inspect the timing control valve operation.

    1. Connect the battery's positive (+) lead to the timing control terminal +B.

    2. Connect the battery's negative (-) lead to the timing control valve terminal TCV.

    3. Check that the solenoid makes a "click" sound.

      NOTICE:
      1. Do not apply voltage for more than 30 seconds to avoid burning out the timing control valve solenoid.
      2. When performing this step, wait until the solenoid coils become cool enough that the solenoid can be touched by hand.

      If the result is not as specified, replace the timing control valve.

← COMPONENTS (from Jun 2011)REMOVAL (from Jun 2011) →