REASSEMBLY
Removal / installation · Vehicles built from Jun 2011
| 1. INSTALL GENERATOR ROTOR ASSEMBLY |
- NOTICE:
- Do not drop the generator rotor assembly.
Set the spacer ring, drive end frame, generator rotor assembly and SST1 to SST2 as shown in the illustration.

- SST
- 09285-76010
09630-00014 (09631-00061)
Using SST1, SST2 and a press, slowly press the generator rotor into the drive end frame and spacer ring.
| 2. INSTALL GENERATOR PULLEY |
Fix the generator in a vise between aluminum plates.
- NOTICE:
- Do not damage the generator.
Temporarily install the washer and generator pulley with the nut.
Set SST, a ball joint lock nut wrench and an 8 mm bi-hexagon wrench as shown in the illustration.

- SST
- 09820-30020
Hold the 8 mm bi-hexagon wrench in place and turn SST and the ball joint lock nut wrench clockwise to tighten the nut.
- Torque:
- 80 N*m{ 816 kgf*cm , 59 ft.*lbf } without ball joint lock nut wrench
- 53 N*m{ 540 kgf*cm , 39 ft.*lbf } with ball joint lock nut wrench
- NOTICE:
- Do not use a tool such as an impact wrench or equivalent.
- HINT:
- Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).
- Make sure the ball joint lock nut wrench and torque wrench are connected in a straight line.
- Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).
Check that the generator pulley rotates smoothly.
| 3. INSTALL FITTING RING |
Align the 3 cutouts of the fitting ring with the stator generator with rectifier.

| 4. INSTALL GENERATOR STATOR SUB-ASSEMBLY WITH RECTIFIER |
Align the key of the drive end frame with the keyway of the generator stator.
Install the stator with the 4 bolts.

- Torque:
- 4.3 N*m{ 44 kgf*cm , 38 in.*lbf }
| 5. INSTALL GENERATOR REGULATOR SUB-ASSEMBLY WITH BRUSH |
Attach the brushes and terminals to the rectifier end frame of the regulator.

Install the regulator with the 3 screws.


- Torque:
- 2.2 N*m{ 22 kgf*cm , 19 in.*lbf } for screw A
- 1.2 N*m{ 12 kgf*cm , 11 in.*lbf } for screw B
- HINT:
- Install screw B to the position shown in the illustration.
| 6. INSTALL GENERATOR REAR END COVER |
Install the rear end cover with the 2 nuts and screw.

- NOTICE:
- The protective tower must be attached on the end cover.
- Torque:
- 19 N*m{ 194 kgf*cm , 14 ft.*lbf } for nut A
- 12 N*m{ 122 kgf*cm , 9 ft.*lbf } for nut B
- 2.4 N*m{ 24 kgf*cm , 21 in.*lbf } for screw
Install the 2 terminal covers by turning them clockwise.

