2014 Hilux · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Jun 2011


INSPECT GENERATOR ROTOR ASSEMBLY

  1. A117277
    Check the rotor for an open circuit.

    1. Measure the resistance between the slip rings.

      Standard resistance:
      1.8 to 2.8 Ω at 20°C (68°F)

      If the result is not as specified, replace the rotor assembly.

  1. A117278
    Check if the rotor is grounded.

    1. Measure the resistance between the slip ring and rotor.

      Standard resistance:
      10 kΩ or higher

      If the result is not as specified, replace the rotor assembly.

  1. Check that the slip rings are not rough or scored.
    If rough or scored, replace the rotor assembly.

  1. A117279
    Using a vernier caliper, measure the slip ring diameter.

    Standard diameter:
    15.3 to 15.5 mm (0.602 to 0.610 in.)

    Minimum diameter:
    14.9 mm (0.587 in.)

    If the diameter is less than the minimum, replace the rotor assembly.


INSPECT GENERATOR STATOR SUB-ASSEMBLY WITH RECTIFIER

A117280E01

HINT:
For terminal positions of the stator generator, refer to the illustration below.

  1. A117281
    Inspect the positive (+) rectifier.

    HINT:
    Inspect the positive terminal after pulling it up.


    1. Using an ohmmeter, connect one tester probe to the positive (+) terminal and the other to each rectifier terminal.

    2. Reverse the polarity of the tester probes and repeat the step above.

    3. Check that one shows a resistance of below 1 Ω and the other shows a resistance of 10 kΩ or higher.
      If the result is not as specified, replace the generator stator sub-assembly with rectifier.

  1. A117282
    Inspect the negative (-) rectifier.

    1. Using an ohmmeter, connect one tester probe to each negative (-) terminal and the other to each rectifier terminal.

    2. Reverse the polarity of the tester probes and repeat the step above.

    3. Check that one shows a resistance of below 1 Ω and the other shows a resistance of 10 kΩ or higher.
      If the result is not as specified, replace the generator stator sub-assembly with rectifier.

  1. A117283
    Inspect the stator coil for an open circuit.

    1. Measure the resistance between the rectifier terminals.

      Standard resistance:
      Below 1 Ω

      If the result is not as specified, replace the generator stator sub-assembly with rectifier.


INSPECT BRUSH

A117284E01
  1. Using a vernier caliper, measure the exposed brush length.

    Standard exposed length on new brush:
    13.2 mm (0.520 in.)

    Minimum exposed length:
    6.0 mm (0.236 in.)

    If the exposed length is less than the minimum, replace the generator regulator sub-assembly with brush.

← DISASSEMBLY (from Jun 2011)REASSEMBLY (from Jun 2011) →