2014 Hilux · Service Manual BODY ELECTRICAL

No Answer-back

Circuit diagnosis · Vehicles built Jun 2011 – Jul 2013

Versions by build date: Jun 2011 – Jul 2013 from Aug 2013

DESCRIPTION

In some cases, wireless control functions are normal but one or more of the following may occur:
  1. The hazard warning light answer-back function is not normal (the theft warning ECU assembly's turn signal flasher assembly output may be malfunctioning).
  2. The security horn answer-back function is not normal (the security horn assembly signal output may be malfunctioning)*.

HINT:
*: The security horn applies only if the wireless answer-back function has been customized so that the hazard warning lights flash and the security horn sounds.


WIRING DIAGRAM

B287295E01

INSPECTION PROCEDURE

NOTICE:
When replacing the theft warning ECU assembly, refer to the registration procedures (Click here).


1. CHECK WIRELESS DOOR LOCK CONTROL FUNCTION
  1. Check the wireless door lock functions by operating the transmitter switches.

    Result 
    Result
    Proceed to
    Only hazard warning light and side turn signal light answer-back does not occur
    A
    Only security horn answer-back does not occur
    B

    HINT:
    The security horn applies only if the wireless answer-back function has been customized so the hazard warning lights flash and the security horn sounds.



B
Go to THEFT DETERRENT SYSTEM (Click here)
A


2. CHECK HAZARD WARNING LIGHTS
  1. Check that the hazard warning lights flash when the hazard warning signal switch is pressed.

    OK:
    Hazard warning lights flash.



NG
Go to LIGHTING SYSTEM (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU - TURN SIGNAL FLASHER)
  1. Disconnect the T36*1 or T39*2 theft warning ECU assembly connector.

    1. *1: except 2 Step Unlock Function
    2. *2: for 2 Step Unlock Function

  1. Disconnect the T22 turn signal flasher assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    except 2 Step Unlock Function:
    Tester Connection
    Condition
    Specified Condition
    T36-28 (HAZD) - T22-8 (HAZ)
    Always
    Below 1 Ω
    T36-28 (HAZD) or T22-8 (HAZ) - Body ground
    Always
    10 kΩ or higher
    for 2 Step Unlock Function:
    Tester Connection
    Condition
    Specified Condition
    T39-23 (HAZD) - T22-8 (HAZ)
    Always
    Below 1 Ω
    T39-23 (HAZD) or T22-8 (HAZ) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE THEFT WARNING ECU ASSEMBLY


← Only Wireless Control Function is Inoperative (from Aug 2013)No Answer-back (from Aug 2013) →