REMOVAL
Removal / installation · Vehicles built from Jun 2011
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- Use the same procedures for the RH side and LH side.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE NO. 1 SWITCH HOLE BASE |
![]() ![]() |
Put protective tape around the No. 1 switch hole base.
Text in Illustration *1
Protective Tape
Using a moulding remover, detach the 5 claws.
Disconnect the connectors and remove the No. 1 switch hole base.
| 3. REMOVE HEADLIGHT LEVELING SWITCH |
![]() ![]() |
Detach the 2 claws and remove the headlight leveling switch.



