REMOVAL
Removal / installation · Vehicles built from Jun 2011
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
| 1.
REMOVE NO. 1 SWITCH HOLE BASE |
 |
- Put protective tape around the No. 1 switch hole base.
Text in Illustration
*1
|
Protective Tape
|
Using moulding remover D, detach the 5 claws and remove the No. 1 switch hole base.
Disconnect the connectors.
| 2.
REMOVE REAR FOG LIGHT SWITCH |
 |
- Detach the 2 claws and remove the rear fog light switch.