ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jun 2011
| CHECK REAR FOG LIGHT SWITCH |
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
1 (E) - Body ground
Always
Below 1 Ω
6 (LH) - Body ground
Headlight dimmer switch off
10 kΩ or higher
Headlight dimmer switch HEAD
Below 1 Ω
7 (FS) - Body ground
headlight dimmer switch (fog light switch) off
10 kΩ or higher
headlight dimmer switch (fog light switch) on
Below 1 Ω
8 (L) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
3 (ILL+) - Body ground
Headlight dimmer switch off
Below 1 V
Headlight dimmer switch TAIL or HEAD
11 to 14 V
4 (B) - Body ground
Always
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Rear Fog Light Switch)
