2014 Hilux · Service Manual ENGINE

18 (5) Spill Control Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Jun 2011

DESCRIPTION

The ECM controls the fuel injection volume by operating the spill control valve. The spill control valve is mounted on the injection pump, and opens or closes the injection pressure releasing port with the solenoid valve in the spill control valve. During injection, valve is closed (ON). The ECM decides the basic fuel injection volume based on the engine rpm and accelerator pedal opening angle, and calculates the final fuel injection angle to add the various corrections on the basic fuel injection volume. The ECM counts the NE pulse to detect the angle from injection starts and operates the spill control valve from ON to OFF (the injection pressure releasing port is open) at the position which watches the final fuel injection angle.
A119268E01
DTC No.
DTC Detection Condition
Trouble Area
18 (5)
Open or short in spill control valve at 500 rpm or more
  1. Open or short in spill control valve circuit
  2. Spill control valve
  3. ECM

WIRING DIAGRAM

A261026E01

INSPECTION PROCEDURE


1. INSPECT SPILL CONTROL VALVE

  1. A105094E01
    Disconnect the spill control valve connector.

  1. Measure the resistance of the spill control valve.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    1 to 2 Ω

    HINT:
    The spill control valve is integrated with the injection pump. If the spill control valve needs to be replaced, the entire injection pump must be replaced.



NG
REPLACE INJECTION PUMP ASSEMBLY
OK


2. CHECK ECM (SPV+ VOLTAGE)

  1. A062416E44
    Disconnect the S26 spill control valve connector.

  1. Turn the ignition switch ON.

  1. Measure the voltage of the ECM connector.

    Standard voltage:
    Tester Connection
    Specified Condition
    E23-12 (SPV+) - E23-14 (E1)
    9 to 14 V



NG
REPLACE ECM
OK


3. CHECK ECM (SPV- VOLTAGE)

  1. A110527E03
    Turn the ignition switch ON.

  1. Measure the voltage of the ECM connector.

    Standard voltage:
    Tester Connection
    Specified Condition
    E23-25 (SPV-) - E23-14 (E1)
    9 to 14 V

  1. While idling, measure the waveform with an oscilloscope connected between the specified terminals of ECM connector.

    OK:
    Tester Connection
    Specified Condition
    SPV- (E23-25) - E1 (E23-14)
    Correct waveform is as shown



OK
CHECK FOR INTERMITTENT PROBLEMS
NG


4. CHECK WIRE HARNESS (ECM - SPILL CONTROL VALVE)

  1. A110528E03
    Disconnect the S26 spill control valve connector.

  1. Disconnect the E23 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    S26-2 - E23-12 (SPV+)
    Below 1 Ω
    S26-1 - E23-25 (SPV-)
    Below 1 Ω
    E23-12 (SPV+) - Body ground
    10 kΩ or higher
    E23-25 (SPV-) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE ECM


← 17 (1) Interior IC Malfunction (from Aug 2014)19 (1) Accelerator Position Sensor Circuit Malfunction (Jun 2011 – Oct 2011) →