2014 Hilux · Service Manual ENGINE

32 (1) Injection Pump System Malfunction

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Jun 2011 – Oct 2011 Nov 2011 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

To compensate for the change in injection volume and injection timing caused by the variance in the injection pump itself, a correction is made by using the data that is stored in the ROM in the fuel pump correction unit.
DTC No.
DTC Detection Condition
Trouble Area
32 (1)
  1. When ignition switch is turned ON, or when ECM determines if there is error in RAM of ECM, ECM conducts single communication. If one of following conditions occurs in single communication, ECM conducts another communication. While ECM is conducting communication, ECM detects DTC 32 (1) if (a) occurs 20 times continuously, (b) occurs 20 times continuously, or (c) occurs 2 times continuously.
  2. (a) There was communication error when receiving data.
  3. (b) Data sent from injection pump correction unit does not match data received in ECM.
  4. (c) Data received from pump ROM is not input for 1024 msec.

    HINT:
    Even when determining process is completed normally, if undefined code is found while checking identification code of data received, ECM conducts communication again. If undefined code occurs 20 times continuously, ECM detects DTC 32 (1).

  1. Open or short in injection pump correction unit circuit
  2. Injection pump correction unit
  3. ECM

WIRING DIAGRAM

A261029E01

INSPECTION PROCEDURE


1. CHECK WIRE HARNESS (ECM - INJECTION PUMP CORRECTION UNIT)

  1. A110537E02
    Disconnect the I13 injection pump correction unit connector.

  1. Disconnect the E22 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    I13-1 (DATA) - E22-6 (DATA)
    Below 1 Ω
    CLK (I13-4) - CLK (E22-14)
    Below 1 Ω
    E22-6 (DATA) - Body ground
    10 kΩ or higher
    E22-14 (CLK) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2. REPLACE INJECTION PUMP ASSEMBLY

NEXT


3. CHECK DTC OUTPUT (DTC 32 (1) IS OUTPUT AGAIN)
  1. Clear the DTC (Click here).

  1. Turn the ignition switch ON.

  1. Check the DTC (Click here).

    Result:
    Display (DTC output)
    Proceed to
    DTC 32 (1) is output again
    A
    No DTC output
    B



B
SYSTEM OK
A

REPLACE ECM


← 32 (1) Injection Pump System Malfunction (Nov 2011 – Jul 2013)32 (1) Injection Pump System Malfunction (from Aug 2014) →