INSPECTION
Inspection · Vehicles built from Jun 2011
| INSPECT PROPELLER SHAFT AND INTERMEDIATE SHAFT |
![]() ![]() |
Using a dial indicator, measure the propeller shaft and intermediate shaft runout.
- Maximum runout:
Item
Specified Condition
Propeller shaft
0.3 mm (0.012 in.)
Intermediate shaft
0.5 mm (0.02 in.)
| INSPECT UNIVERSAL JOINT SPIDER ASSEMBLY |
Check the spider bearings for wear or damage.
Check each spider bearing's axial play by turning the yoke while holding the shaft tightly.
- Maximum bearing axial play:
- 0 to 0.05 mm (0 to 0.002 in.)
| INSPECT CENTER NO. 1 SUPPORT BEARING ASSEMBLY |
![]() ![]() |
When turning the center bearing with your hand, check that it turns smoothly without catching, and that there are no cracks or damage.
If there are any defects, replace it.
If there is any damage to the lip of the center bearing case, replace it.



