2014 Hilux · Service Manual DRIVE LINE

INSPECTION

Inspection · Vehicles built from Jun 2011


INSPECT PROPELLER SHAFT AND INTERMEDIATE SHAFT

C061260E02
  1. Using a dial indicator, measure the propeller shaft and intermediate shaft runout.

    Maximum runout:
    Item
    Specified Condition
    Propeller shaft
    0.8 mm (0.031 in.)
    Intermediate shaft
    0.8 mm (0.031 in.)

    If the runout is greater than the maximum, replace the shaft.


INSPECT UNIVERSAL JOINT SPIDER ASSEMBLY
  1. Check the spider bearings for wear or damage.

  1. Check each spider bearing's axial play by turning the yoke while holding the shaft tightly.

    Maximum bearing axial play:
    0 to 0.05 mm (0 to 0.002 in.)

    If the axial play is greater than the maximum, replace the spider bearing.


INSPECT CENTER NO. 1 SUPPORT BEARING ASSEMBLY

C118618
  1. When turning the center bearing with your hand, check that it turns smoothly without catching and that there are no cracks or damage.
    If there are any defects, replace it.
    If there are any damage to the lip of the center bearing case, replace it.

← DISASSEMBLY (from Jun 2011)REASSEMBLY (from Jun 2011) →