REMOVAL
Removal / installation · Vehicles built from Jun 2011
- HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
- Use the same procedure for the RH and LH sides.
| 1. REMOVE FRONT WHEEL |
| 2. DRAIN BRAKE FLUID |
- NOTICE:
- Wash off brake fluid immediately if it comes in contact with any painted surface.
| 3. REMOVE FRONT FLEXIBLE HOSE |
Remove the union bolt and gasket and disconnect the front flexible hose.
Using a union nut wrench, disconnect the brake line while holding the front flexible hose with a wrench.

- NOTICE:
- Do not kink or damage the brake line.
- Do not allow any foreign matter such as dirt or dust to enter the brake line.
- Do not kink or damage the brake line.
Remove the clip.
Remove the bolt and front flexible hose from the absorber bracket.
