2014 Hilux · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Jun 2011


INSPECT FRONT DOOR LOCK ASSEMBLY (DRIVER SIDE)

B111989E01
  1. Apply battery voltage to the door lock and check operation of the door lock motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 4
    Battery negative (-) → Terminal 1
    Lock
    Battery negative (+) → Terminal 1
    Battery positive (-) → Terminal 4
    Unlock

    1. If the result is not as specified, replace the door lock assembly.

  1. B111990E02
    Measure the resistance of the door lock and unlock switch.

    Standard resistance:
    LHD:
    Tester Connection
    Door Lock Condition
    Specified Condition
    7 - 9
    Lock
    Below 1 Ω
    7 - 9, 7 - 10
    OFF
    10 kΩor higher
    7 - 10
    Unlock
    Below 1 Ω
    RHD:
    Tester Connection
    Door Lock Condition
    Specified Condition
    6 - 8
    Lock
    Below 1 Ω
    5 - 8, 6- 8
    OFF
    10 kΩor higher
    5 - 8
    Unlock
    Below 1 Ω

    1. If the result is not as specified, replace the door lock assembly.

  1. w/ Wireless door lock system, w/o Theft deterrent system:
    Measure the resistance of the detection switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    7 - 8
    Lock
    10 kΩ or higher
    7 - 8
    Unlock
    Below 1 Ω

    1. If the result is not as specified, replace the door lock assembly.


INSPECT FRONT DOOR LOCK ASSEMBLY (PASSENGER SIDE)

B111996E01
  1. Apply battery voltage to the door lock and check operation of the door lock motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 4
    Battery negative (-) → Terminal 1
    Lock
    Battery negative (+) → Terminal 1
    Battery positive (-) → Terminal 4
    Unlock

    1. If the result is not as specified, replace the door lock assembly.

← INSTALLATION (from Jun 2011)INSPECTION (from Jun 2011) →