The sound signals amplified by the radio receiver assembly are sent to the speakers from the radio receiver assembly via the speaker circuit. If there is a short in a speaker circuit, the radio receiver assembly detects it and stops output to the speakers. Thus sound cannot be heard from the speakers even if there is not a malfunction in the radio receiver assembly or speakers.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. CHECK HARNESS AND CONNECTOR (SPEAKER CIRCUIT)
*1: for RH Side
*2: for LH Side
*3: except 2 Speakers
Disconnect the R1 and/or R2*3 radio receiver assembly connector.
Disconnect the S16*1 and/or S15*2 front No. 1 speaker assembly connector.
for Double Cab:Disconnect the T24*1 and/or T23*2 front No. 2 speaker assembly connector.
for Double Cab:Disconnect the S18*1 and/or S17*2 rear speaker assembly connector.
for Extra Cab:Disconnect the S20*1 and/or S19*2 rear speaker assembly connector.
Standard Resistance:
for 6 Speakers RH Side
Tester Connection
Condition
Specified Condition
R1-1 (FR+) - T24-4
Always
Below 1 Ω
R1-5 (FR-) - T24-2
Always
Below 1 Ω
T24-3 (+) - S16-1
Always
Below 1 Ω
T24-1 (-) - S16-2
Always
Below 1 Ω
R2-1 (RR+) - S18-1
Always
Below 1 Ω
R2-3 (RR-) - S18-2
Always
Below 1 Ω
R1-1 (FR+) - Body ground
Always
10 kΩ or higher
R1-5 (FR-) - Body ground
Always
10 kΩ or higher
T24-3 - Body ground
Always
10 kΩ or higher
T24-1 - Body ground
Always
10 kΩ or higher
R2-1 (RR+) - Body ground
Always
10 kΩ or higher
R2-3 (RR-) - Body ground
Always
10 kΩ or higher
for 6 Speakers LH Side
Tester Connection
Condition
Specified Condition
R1-2 (FL+) - T23-4
Always
Below 1 Ω
R1-6 (FL-) - T23-2
Always
Below 1 Ω
T23-3 - S15-1
Always
Below 1 Ω
T23-1 - S15-2
Always
Below 1 Ω
R2-2 (RL+) - S17-1
Always
Below 1 Ω
R2-6 (RL-) - S17-2
Always
Below 1 Ω
R1-2 (FL+) - Body ground
Always
10 kΩ or higher
R1-6 (FL-) - Body ground
Always
10 kΩ or higher
T23-3 - Body ground
Always
10 kΩ or higher
T23-1 - Body ground
Always
10 kΩ or higher
R2-2 (RL+) - Body ground
Always
10 kΩ or higher
R2-6 (RL-) - Body ground
Always
10 kΩ or higher
except 6 Speakers RH Side (for Double Cab)
Tester Connection
Condition
Specified Condition
R1-1 (FR+) - S16-1
Always
Below 1 Ω
R1-5 (FR-) - S16-2
Always
Below 1 Ω
R2-1 (RR+) - S18-1*
Always
Below 1 Ω
R2-3 (RR-) - S18-2*
Always
Below 1 Ω
R1-1 (FR+) - Body ground
Always
10 kΩ or higher
R1-5 (FR-) - Body ground
Always
10 kΩ or higher
R2-1 (RR+) - Body ground*
Always
10 kΩ or higher
R2-3 (RR-) - Body ground*
Always
10 kΩ or higher
except 6 Speakers LH Side (for Double Cab)
Tester Connection
Condition
Specified Condition
R1-2 (FL+) - S15-1
Always
Below 1 Ω
R1-6 (FL-) - S15-2
Always
Below 1 Ω
R2-2 (RL+) - S17-1*
Always
Below 1 Ω
R2-6 (RL-) - S17-2*
Always
Below 1 Ω
R1-2 (FL+) - Body ground
Always
10 kΩ or higher
R1-6 (FL-) - Body ground
Always
10 kΩ or higher
R2-2 (RL+) - Body ground*
Always
10 kΩ or higher
R2-6 (RL-) - Body ground*
Always
10 kΩ or higher
except 6 Speakers RH Side (except Double Cab)
Tester Connection
Condition
Specified Condition
R1-1 (FR+) - S16-1
Always
Below 1 Ω
R1-5 (FR-) - S16-2
Always
Below 1 Ω
R2-1 (RR+) - S20-1*
Always
Below 1 Ω
R2-3 (RR-) - S20-2*
Always
Below 1 Ω
R1-1 (FR+) - Body ground
Always
10 kΩ or higher
R1-5 (FR-) - Body ground
Always
10 kΩ or higher
R2-1 (RR+) - Body ground*
Always
10 kΩ or higher
R2-3 (RR-) - Body ground*
Always
10 kΩ or higher
except 6 Speakers LH Side (except Double Cab)
Tester Connection
Condition
Specified Condition
R1-2 (FL+) - S15-1
Always
Below 1 Ω
R1-6 (FL-) - S15-2
Always
Below 1 Ω
R2-2 (RL+) - S19-1*
Always
Below 1 Ω
R2-6 (RL-) - S19-2*
Always
Below 1 Ω
R1-2 (FL+) - Body ground
Always
10 kΩ or higher
R1-6 (FL-) - Body ground
Always
10 kΩ or higher
R2-2 (RL+) - Body ground*
Always
10 kΩ or higher
R2-6 (RL-) - Body ground*
Always
10 kΩ or higher
*: for 4 Speakers
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
2. INSPECT FRONT NO. 1 SPEAKER ASSEMBLY
Disconnect the S16*1 and/or S15*2 front No. 1 speaker assembly connector.
*1: for RH
*2: for LH
Inspect the front No. 1 speaker assembly (Click here).