2014 Hilux · Service Manual BODY ELECTRICAL

Data Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter

Circuit diagnosis · Vehicles built from Aug 2013

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the navigation receiver assembly via this circuit.

WIRING DIAGRAM

E278092E04

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the N13 navigation receiver assembly connector.

  1. Disconnect the N14 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    N13-2 (US1-) - N14-2 (US1-)
    Always
    Below 1 Ω
    N13-3 (US1+) - N14-3 (US1+)
    Always
    Below 1 Ω
    N13-2 (US1-) - Body ground
    Always
    10 kΩ or higher
    N13-3 (US1+) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Sound Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter (from Aug 2013)Reverse Signal Circuit (from Aug 2013) →