Reverse Signal Circuit
Circuit diagnosis · Vehicles built from Aug 2013
DESCRIPTION
The navigation receiver assembly receives a reverse signal from the park/neutral position switch assembly*1 or back-up light switch assembly*2.- *1: for Automatic Transmission
- *2: for Manual Transmission
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK VEHICLE SIGNAL (OPERATION CHECK) |
Enter the "Vehicle Signal Check Mode" screen. Refer to check Vehicle Signal in Operation Check (Click here).

Check that the display changes between ON and OFF according to the shift lever position.
- OK:
Shift Lever Position
Display
R
ON
Except R
OFF
- HINT:
- This display is updated once per second. As a result, it is normal for the display to lag behind the actual shift lever position.
|
|
||||
| OK | ||
| ||
| 2. CHECK NAVIGATION RECEIVER ASSEMBLY |
![]() ![]() |
Disconnect the N9 navigation receiver assembly connector.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
N9-2 (REV) - Body ground
Ignition switch ON, shift lever in R
7.5 to 14 V
N9-2 (REV) - Body ground
Ignition switch ON, shift lever not in R
Below 1 V
Text in Illustration *a
Front view of wire harness connector
(to Navigation Receiver Assembly)
Result Result
Proceed to
OK
A
NG (for Automatic Transmission)
B
NG (for Manual Transmission)
C
|
|
||||
|
|
||||
| A | ||
| ||
| 3. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARK/NEUTRAL POSITION SWITCH ASSEMBLY) |
Disconnect the N9 navigation receiver assembly connector.
Disconnect the N8 park/neutral position switch assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
N9-2 (REV) - N8-1 (RL)
Always
Below 1 Ω
N9-2 (REV) - Body ground
Always
10 kΩ or higher
Result Result
Proceed to
OK (for A750E)
A
OK (for A750F)
B
NG
C
|
|
||||
|
|
||||
| A | ||
| ||
| 4. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - BACK-UP LIGHT SWITCH ASSEMBLY) |
Disconnect the N9 navigation receiver assembly connector.
Disconnect the B1 back-up light switch assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
N9-2 (REV) - B1-1
Always
Below 1 Ω
N9-2 (REV) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||

