REMOVAL
Removal / installation · Vehicles built from Aug 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
- Use the same procedure for RHD and LHD vehicles.
| 1. REMOVE NO. 1 SWITCH HOLE BASE |
![]() ![]() |
Put protective tape around the No. 1 switch hole base.
Text in Illustration *1
Protective Tape
Using a moulding remover, detach the 5 claws.
Disconnect the connectors and remove the No. 1 switch hole base.
| 2. REMOVE LIGHT CONTROL RHEOSTAT KNOB |
![]() ![]() |
Detach the claw and remove the light control rheostat knob.
| 3. REMOVE LIGHT CONTROL RHEOSTAT |
![]() ![]() |
Remove the nut and light control rheostat.




