2014 Hilux · Service Manual BRAKE

43 ABS Control System Malfunction

Diagnostic trouble codes · Vehicles built Apr 2012 – Jul 2012

Versions by build date: Jun 2011 – Oct 2011 Nov 2011 – Mar 2012 Apr 2012 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This DTC is stored when the VSC system detects a malfunction in the anti-lock brake system.
DTC Code
DTC Detection Condition
Trouble Area
43
A malfunction in the anti-lock brake system.
Anti-lock brake system

INSPECTION PROCEDURE

NOTICE:
After replacing the brake actuator assembly, perform calibration (Click here).


1. CHECK ANTI-LOCK BRAKE SYSTEM
  1. Check if an ABS DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
REPAIR CIRCUIT INDICATED BY OUTPUT DTC (Click here)
A


2. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Turn the ignition switch off.

  1. Start the engine.

  1. Drive the vehicle at a speed of approximately 40 km/h (25 mph) or more for 60 seconds or more.

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    for LHD
    B
    for RHD
    C



B
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)

C
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← 43 ABS Control System Malfunction (Nov 2011 – Mar 2012)43 ABS Control System Malfunction (Aug 2012 – Jul 2013) →