ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jun 2011
| INSPECT OIL QUALITY |
Check the engine oil for deterioration, water contamination, discoloration or thinning.
If the quality is visibly poor, replace the engine oil and oil filter (Click here).
| INSPECT ENGINE OIL LEVEL |
Warm up the engine, stop the engine and wait 5 minutes. The engine oil level should be between the dipstick low level mark and full level mark.
If low, check for leakage and add oil up to the full level mark.- NOTICE:
- Do not fill engine oil above the full level mark.
| INSPECT ENGINE OIL PRESSURE |
Remove the engine oil pressure switch (Click here).
Install an oil pressure gauge with an adapter.

Text in Illustration *1
Oil Pressure Gauge
*2
Adapter
Warm up the engine.
Measure the engine oil pressure.
- Standard Oil Pressure:
Condition
Specified Condition
Idle
29 kPa (0.3 kgf/cm2, 4.2 psi) or higher
3000 rpm
245 kPa (2.5 kgf/cm2, 36 psi) or higher
Remove the oil pressure gauge and adapter.
Install the engine oil pressure switch (Click here).
