2014 Hilux · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Jun 2011


INSPECT ELECTRIC EGR CONTROL VALVE ASSEMBLY

  1. A147237
    Inspect the electric EGR control valve.

    1. When a vacuum of 26.7 kPa (200 mmHg, 7.87 in.Hg) is applied to the diaphragm chamber, check that the shaft rises and that air flows out.

    2. Maintaining the above conditions, check that there are no leaks and that the shaft stays in position.

    3. Check that the valve does not have heavy carbon deposits and is not stuck.
      If the result is not as specified, replace the electric EGR control valve.

  1. A085764E03
    Inspect the EGR valve position sensor.

    1. Measure the resistance between terminals 1 (VC) and 2 (E2) of the EGR valve position sensor.

      Standard resistance:
      2.8 to 7.8 kΩ at 20°C (68°F)

      If the result is not as specified, replace the electric EGR control valve.

  1. A147238E01
    Crate a vacuum in the diaphragm chamber. Check the resistance between terminals 3 (EGLS) and 2 (E2) of the lift sensor when the valve is fully opened and fully closed.

    Standard resistance:
    EGR Valve Condition
    Specified Condition
    Fully opened
    2.0 to 7.0 kΩ at 20°C (68°F)
    Fully closed
    0.1 to 2.5 kΩ at 20°C (68°F)

    HINT:
    The resistance increases in proportion to the opening angle of the EGR valve.
    If the result is not as specified, replace the electric EGR control valve.


INSPECT NO. 2 EGR VALVE ASSEMBLY

  1. A147245
    When a vacuum of 33.3 kPa (250 mmHg, 9.833 in.Hg) or more is applied to the diaphragm chamber, check that the valve turns and that air flows out.

  1. Maintaining the above conditions, check that there are no leaks and that the valve does not return.

  1. Check that the valve does not have heavy carbon deposits and is not stuck.
    If the result is not as specified, replace the No. 2 EGR valve.

← REMOVAL (from Jun 2011)INSTALLATION (Jun 2011 – Jul 2012) →