REMOVAL
Removal / installation · Vehicles built from Jun 2011
- NOTICE:
- When replacing the fuel supply pump, also replace the injection pipe.
- After removing the injection pipes and fuel inlet pipe, clean them with a brush and compressed air.
- When replacing the fuel supply pump, also replace the injection pipe.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE NO. 1 ENGINE UNDER COVER |
Remove the 4 bolts and under cover.
| 3. REMOVE NO. 2 ENGINE UNDER COVER |
Remove the 2 bolts and under cover.
| 4. LOOSEN FUEL TANK CAP ASSEMBLY |
| 5. DRAIN FUEL |
| 6. DRAIN AUTOMATIC TRANSMISSION FLUID |
| 7. DRAIN RADIATOR ASSEMBLY |
Remove the radiator assembly. (Click here)
| 8. REMOVE TIMING BELT |
Remove the No.1 timing belt. (Click here)
| 9. REMOVE FUEL INLET PIPE SUB-ASSEMBLY |
Remove the bolt and clamp.

Remove the bolt and oil level gauge guide.

Using a 17 mm union nut wrench, loosen the union nuts and remove the fuel inlet pipe.

| 10. REMOVE SUPPLY PUMP ASSEMBLY |
Disconnect the 2 fuel hoses.

Disconnect the 2 connectors.

Remove the 4 bolts indicated by the arrows in the illustration.

Remove the No. 2 camshaft timing pulley flange and pump drive shaft pulley.
Remove the set nut and O-ring while holding the crankshaft pulley by using SST.

- SST
- 09213-58013
09330-00021
Loosen the 2 nuts.

Using SST, disconnect the pump from the injection gear.

- SST
- 09950-50013
(09951-05010, 09952-05010, 09953-05020, 09954-05021)
- NOTICE:
- Apply lubricant to the threads and tip of SST (center bolt) before using it.
Remove the 2 nuts and pump.
- NOTICE:
- Do not hold the pump or carry it holding the pipe.
- The pump must be kept horizontal.
- Do not hold the pump or carry it holding the pipe.
Remove the O-ring.
