2014 Hilux · Service Manual BODY ELECTRICAL

Speed Signal Circuit

Circuit diagnosis · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

DESCRIPTION

This circuit is necessary for the ASL (Auto Sound Levelizer) built into the radio receiver assembly. Speed signals are received from the combination meter and used for the ASL.
The ASL function automatically adjusts the sound data in order to enable the listener to hear the sound of the audio system clearly even when vehicle noise increases (as vehicle noise increases, the volume is turned up, etc.).

HINT:
  1. A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter. The signal is changed to a pulse signal at the transistor in the combination meter. Each ECU controls its respective system based on the pulse signal.
  2. If a short occurs in any of the ECUs or in the wire harness connected to an ECU, both systems in the diagram below will not operate normally.


WIRING DIAGRAM

E230298E01

INSPECTION PROCEDURE


1. CHECK OPERATION OF SPEEDOMETER
  1. Drive the vehicle and check if the function of the speedometer in the combination meter is normal.

    OK:
    Actual vehicle speed and the speed indicated on the speedometer are the same.

    HINT:
    The vehicle speed sensor is functioning normally when the indication on the speedometer is normal.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - COMBINATION METER)
  1. Disconnect the R17 radio receiver assembly connector.

  1. Disconnect the C25 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R17-17 (SPD) - C25-6
    Always
    Below 1 Ω
    R17-17 (SPD) - Body ground*1
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE RADIO RECEIVER ASSEMBLY (Click here)


← Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter (Aug 2012 – Jul 2013)Speed Signal Circuit (Aug 2012 – Jul 2013) →