2014 Hilux · Service Manual COMMUNICATION SYSTEM

PRECAUTION

Precautions · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1.STEERING SYSTEM HANDLING PRECAUTIONS
  1. Care must be taken when replacing parts. Incorrect replacement could affect the performance of the steering system and result in hazards when driving.


2.SRS AIRBAG SYSTEM HANDLING PRECAUTIONS
  1. This vehicle is equipped with an SRS (Supplemental Restraint System), which includes components such as the driver airbag and front passenger airbag. Failure to carry out service operations in the correct sequence could cause unexpected SRS deployment during servicing and may lead to a serious accident. Before servicing (including installation/removal, inspection and replacement of parts), be sure to read the precautionary notice for the supplemental restraint system (Click here).


3.BUS LINE REPAIR
E120441
  1. After repairing the bus line with solder, wrap the repaired part with vinyl tape (Click here).

    NOTICE:
    1. The CANL bus line and CANH bus line must be installed together.
    2. When installing the CAN bus lines, twist them together.
    3. CAN bus lines are likely to be influenced by noise if the bus lines are not twisted together.
    4. The difference in length between the CANL bus line and CANH bus line should be less than 100 mm (3.94 in.).
    5. Leave approximately 80 mm (3.15 in.) loose in the twisted wires around the connectors.

  2. E134624E01
    Do not use by-pass wiring between the connectors.

    NOTICE:
    The protective effect of the twisted wire harness will be lost if by-pass wiring is used.


4.CONNECTOR HANDLING
E120443E01
  1. When inserting tester probes into a connector, insert them from the rear of the connector.

  2. E120444E01
    Use a repair wire to check the connector if it is impossible to check resistance from the rear of the connector.

← INSTALLATION (from Jun 2011)PRECAUTION (Aug 2012 – Jul 2013) →