2014 Hilux · Service Manual COMMUNICATION SYSTEM

Skid Control ECU Communication Stop Mode

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

Detection Item
Symptom
Trouble Area
Skid Control ECU Communication Stop Mode
When either condition below is met:
  1. Skid Control (ABS/VSC/TRAC) is not displayed on "Bus Check".
  2. "Skid Control ECU Communication Stop Mode" in "DTC Combination Table" applies.
  1. Power source or inside skid control ECU
  2. Skid control ECU branch wire or connector
  3. Brake actuator assembly (skid control ECU)

WIRING DIAGRAM

C190676E07

INSPECTION PROCEDURE

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable from the negative (-) battery terminal, some systems need to be initialized after the cable is reconnected (Click here).


NEXT


2. CHECK FOR OPEN IN CAN BUS WIRE (SKID CONTROL ECU BRANCH WIRE)

  1. C190680E06
    Disconnect the S35 skid control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    S35-25 (CANH) - S35-14 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE SKID CONTROL ECU BRANCH WIRE OR CONNECTOR (CANH, CANL)
OK


3. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BATTERY AND BODY GROUND)
  1. Reconnect the cable to the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable from the negative (-) battery terminal, some systems need to be initialized after the cable is reconnected (Click here).

  1. C190680E07
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S35-1 (GND1) - Body ground
    Always
    Below 1 Ω
    S35-13 (GND2) - Body ground

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    S35-12 (+BS) - Body ground
    Always
    11 to 14 V
    S35-34 (IG1) - Body ground
    Ignition switch ON

    Result 
    Result
    Proceed to
    OK (for LHD)
    A
    OK (for RHD)
    B
    NG
    C



B
REPLACE BRAKE ACTUATOR ASSEMBLY (SKID CONTROL ECU) (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE BRAKE ACTUATOR ASSEMBLY (SKID CONTROL ECU) (Click here)


← Skid Control ECU Communication Stop Mode (Aug 2013 – Jul 2014)Steering Angle Sensor Communication Stop Mode (Jun 2011 – Jul 2012) →