INSPECTION
Inspection · Vehicles built from Jun 2011
| INSPECT HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY |
Remove the washer jar.
Disconnect the headlight cleaner motor and pump assembly connector.
- HINT:
- Make sure that the headlight cleaner motor and pump assembly is installed to the washer jar.
Fill the washer jar with washer fluid.
After filling washer jar with washer fluid, wake sure that washer fluid does not leak from the seal.
Connect the positive (+) lead of the battery to terminal 2 of the headlight cleaner motor and pump assembly, and the negative (-) lead to terminal 1.

Text in Illustration *a
Component without harness connected
(Headlight Cleaner Motor and Pump Assembly)
Check that washer fluid flows from the washer jar.
- OK:
- Washer fluid flows from the washer jar.
