2014 Hilux · Service Manual BRAKE

C1419 Acceleration Sensor Internal Circuit

Diagnostic trouble codes · Vehicles built Aug 2012 – Jul 2013

Also covers:

Versions by build date: Jun 2011 – Oct 2011 Nov 2011 – Mar 2012 Apr 2012 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The skid control ECU (brake actuator assembly) receives signals from the yaw rate sensor assembly via the CAN communication system.
The yaw rate sensor assembly has a built-in acceleration sensor.
If there is trouble in the bus lines between the yaw rate sensor assembly and the CAN communication system, DTCs U0123 (Lost Communication with Yaw Rate Sensor Module) and U0124 (Lost Communication with Lateral Acceleration Sensor Module) are stored.
DTC C1419 and C1435 are also stored when calibration is not completed.
DTC Code
DTC Detection Condition
Trouble Area
C1419
A data malfunction signal is received from the acceleration sensor.
Acceleration sensor (Yaw rate sensor assembly)
C1435
A data malfunction signal is received from the yaw rate sensor.
Yaw rate sensor assembly

INSPECTION PROCEDURE

NOTICE:
After replacing the yaw rate sensor assembly, perform calibration (Click here).

HINT:
When DTC U0123 and/or U0124 is output together with DTC C1419 and/or C1435, inspect and repair the trouble areas indicated by DTC U0123 and/or U0124 first (Click here).


1. REPLACE YAW RATE SENSOR ASSEMBLY
  1. Replace the yaw rate sensor assembly (Click here).


NEXT

END


← C1419 Acceleration Sensor Internal Circuit (+ C1435) (Apr 2012 – Jul 2012)C1419 Acceleration Sensor Internal Circuit (+ C1435) (Aug 2013 – Jul 2014) →