C1440 Steering Angle Sensor Unusual Bank Angle Detected
Diagnostic trouble codes · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Jun 2011 – Oct 2011 Nov 2011 – Mar 2012 Apr 2012 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
If the skid control ECU (brake actuator assembly) determines that the vehicle is being driven at a steep bank angle, the skid control ECU (brake actuator assembly) stores DTC C1440 while VSC operation is temporarily disabled.It is not a malfunction if the system and sensor circuits are normal and if normal VSC operation resumes, which automatically clears DTC C1440, after the vehicle is returned to a normal position.
- HINT:
- DTC C1440 and the yaw rate and acceleration sensor DTC are stored when the skid control ECU (brake actuator assembly) determines that the vehicle is being driven at a steep bank angle and either of the following conditions is met:
- The yaw rate sensor is installed at an angle.
- The yaw rate sensor signal output is stuck.
- The yaw rate sensor is installed at an angle.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1440 |
Driving at a steep bank angle. |
Yaw rate sensor assembly |
INSPECTION PROCEDURE
| 1. CHECK DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Start the engine.
Perform a road test.
Check if the same DTC is output (Click here).
Result Result
Proceed to
DTC C1440 is output
A
DTC C1440 is not output
B
Yaw rate and acceleration sensor DTC is output
C
|
|
||||
|
|
||||
| A | |
| 2. CLEAR DTC |
Clear the DTC (Click here).
- HINT:
- If the skid control ECU (brake actuator assembly) determines that the vehicle is being driven at a steep bank angle, the skid control ECU stores DTC C1440 while VSC operation is temporarily disabled.
- It is not a malfunction if the system and sensor circuits are normal and if normal VSC operation resumes, which automatically clears DTC C1440, after the vehicle is returned to a normal position.
- If the skid control ECU (brake actuator assembly) determines that the vehicle is being driven at a steep bank angle, the skid control ECU stores DTC C1440 while VSC operation is temporarily disabled.
| NEXT | ||
| ||
