2014 Hilux · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built from Jun 2011

HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).


1. INSTALL FRONT BUMPER SIDE SUPPORT LH
  1. Attach the 2 claws to install the front bumper side support.

  1. Install the bolt and screw.


2. INSTALL FRONT BUMPER SIDE SUPPORT RH

HINT:
Use the same procedure described for the LH side.


3. INSTALL NO. 2 FRONT BUMPER RETAINER BRACKET
  1. Install the No. 2 front bumper retainer bracket with the bolt.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }


4. INSTALL NO. 1 FRONT BUMPER RETAINER BRACKET

HINT:
Use the same procedure described for the No. 2 front bumper retainer bracket.


5. INSTALL RADIATOR SIDE DEFLECTOR LH
  1. Attach the claw to install the radiator side deflector.

  1. Install the 3 clips.


6. INSTALL RADIATOR SIDE DEFLECTOR RH

HINT:
Use the same procedure described for the LH side.


7. INSTALL FRONT BUMPER MOUNTING BRACKET

HINT:
Use the same procedure for both front bumper mounting brackets.

  1. Install the front bumper mounting bracket with the bolt.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }


8. INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY
  1. Install the front bumper reinforcement with the 4 nuts.

    Torque:
    67 N*m{ 683 kgf*cm , 49 ft.*lbf }


9. INSTALL FRONT BUMPER REINFORCEMENT EXTENSION LH (for 4WD and Pre-Runner)
  1. Attach the 2 claws to install the front bumper reinforcement extension.


10. INSTALL FRONT BUMPER REINFORCEMENT EXTENSION RH (for 4WD and Pre-Runner)

HINT:
Use the same procedure described for the LH side.


11. INSTALL ENGINE SIDE COVER SUB-ASSEMBLY LH (for 4WD and Pre-Runner)
  1. Install the engine side cover with the 3 bolts and 2 clips.


12. INSTALL ENGINE SIDE COVER SUB-ASSEMBLY RH (for 4WD and Pre-Runner)

HINT:
Use the same procedure described for the LH side.


13. INSTALL ENGINE UNDER COVER (except 4WD and Pre-Runner)
  1. Install the engine under cover with the 5 bolts and 4 clips.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }


14. INSTALL FRONT BUMPER COVER
  1. w/ Fog Light:
    Connect the 2 fog light connectors.

  1. w/ Headlight Cleaner System:
    Connect the No. 1 headlight cleaner hose.

  1. Attach the 6 claws to install the front bumper cover.

  1. Install the 5 clips, 2 bolts and 2 screws.

  1. Install the 3 clips and 6 screws.


15. INSTALL RADIATOR GRILLE
  1. Attach the 6 claws to install the radiator grille.

  1. Install the 2 screws and 2 clips.


16. ADJUST FOG LIGHT AIMING (w/ Fog Light)
(Click here)
← REASSEMBLY (from Jun 2011)COMPONENTS (from Jun 2011) →