INSTALLATION
Removal / installation · Vehicles built from Aug 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
- CAUTION:
- Wear protective gloves. Sharp areas on the parts may injure your hands.
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for RHD vehicles.
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the RH side.
- Use the same procedure for RHD and LHD vehicles.
| 1. INSTALL FRONT SEAT ASSEMBLY |
Place the front seat assembly in the cabin.
- NOTICE:
- Be careful not to damage the vehicle body.
Connect the connector under the seat.
Connect the cable to the negative (-) battery terminal.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
Temporarily install the front seat assembly with the 4 bolts.
Operate the power seat switch (slide switch) to move the seat to the rearmost position.
Tighten the bolts in the order shown in the illustration.

- Torque:
- 37 N*m{ 377 kgf*cm , 27 ft.*lbf }
Operate the power seat switch (slide switch) to move the seat to the foremost position.
Tighten the bolts in the order shown in the illustration.

- Torque:
- 37 N*m{ 377 kgf*cm , 27 ft.*lbf }
| 2. INSTALL OUTER SEAT TRACK BRACKET COVER |
Attach the 2 claws in the order shown in the illustration to install the outer seat track bracket cover.

- NOTICE:
- Be careful not to damage the claws.
| 3. INSTALL INNER SEAT TRACK BRACKET COVER |
Attach the 2 claws in the order shown in the illustration to install the inner seat track bracket cover.

- NOTICE:
- Be careful not to damage the claws.
| 4. INSTALL FRONT SEAT HEADREST ASSEMBLY |
Install the front seat headrest assembly.
| 5. CHECK SRS WARNING LIGHT (w/ Front Seat Side Airbag) |
| 6. INSPECT FRONT SEAT ASSEMBLY |
Check the power seat operation (Click here).
for LHD, w/ Seat Heater System:
Check the seat heater operation.Turn the ignition switch to ON.
Turn the seat heater switch on.
Wait 5 minutes or more and confirm that the seat surface becomes warm.
